Jewellery School. Rings

#v12722

A ring shaped from a silver-plated wire on a ring stick. It is then decorated with beads which can be attached in two ways; either by “sewing” them on with silver-plated wire or by putting beads onto head pins, attaching them to the ring like pendants.

#v12722
Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

How to do it
Guide step %d
1.   Measure the appropriate ring size using the ring sizer.
Guide step %d
2.   The size can be found on the ring stick.
Guide step %d
3.   Wrap the silver-plated wire tightly around the ring stick at the correct size number.
Guide step %d
4.   Let the two ends overlap and then wrap the ends around the ring. This now forms the bottom of the ring.
Guide step %d
5.   Use a new piece of silver-plated wire; wrap it along the top of the ring towards the middle and bend it straight upwards. Take another piece of silver-plated wire; wrap it along the top of the ring and towards the middle. Wrap the end around the piece which is bent upwards.
Guide step %d
6.   Put the bead onto the stalk.
Guide step %d
7.   Use the tip of round nose pliers to twist the wire forming a coil. Nip off the end.
Guide step %d
Sew beads onto a ring   Fasten the wire to the sieve disc.
Guide step %d
2.   Thread the beads onto the wire 1 – 2 – 3 at a time whilst “sewing” up and down through the holes of the sieve disc – and around the ring.
Guide step %d
Decorate a ring   Put small beads onto head pins and bend them a little to one side and cut off leaving approx. 1cm of the head pin.
Guide step %d
2.   Twist to form a loop (do not close it completely). Use round nose pliers.
Guide step %d
3.   Attach the loop from the headpin onto the loop on the ring. Now close it completely. Attach three pendants to each loop.
Also go exploring in
Copyright © 2021-present Magento, Inc. All rights reserved.