Table Decorations in Natural Colours

#v16865

Set a creative table in soothing, natural colours. Make napkin rings and preserving jars in macramé and flowers out of crepe paper. You can also make place cards out of round wooden discs and handwritten menu cards, both decorated with attractive stamped designs.

#v16865
Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
Macramé Napkin Ring   Cut 6 x 2 m of cord to make six napkin rings. Find the middle of the 2 m of cord to be pulled into the wooden ring.
Guide step %d
2   Pull the ends of the cord through the loop.
Guide step %d
3   Tighten the lark’s head knot.
Guide step %d
4   Knot the left side of the napkin ring first. Pull the cord through the wooden ring and towards you.
Guide step %d
5   Now tighten the knot before continuing.
Guide step %d
6   Now thread the cord backwards through the wooden ring and under itself.
Guide step %d
7   Tighten the lark’s head knot.
Guide step %d
8   The first two knots are now finished.
Guide step %d
9   Continue until half the ring is full – around seven knots.
Guide step %d
10   Make the other half of the ring in the same way with the other half of the first cord. Repeat steps 4-8.
Guide step %d
11   Make loops with the two ends at the bottom on the ring.
Guide step %d
12   Tie a knot and tighten to make a bow.
Guide step %d
13   Thread a wooden bead onto each of the two ends and, if necessary, use a crochet hook or other tool to pull the cord through.
Guide step %d
Macramé Coaster   Cut cords: 1 x 1.2 m + 9 x 45 cm per jar.
Guide step %d
15   Make a loop (magic ring) with 120 cm of cord. Wrap 9 x 45 cm of cord around the loop with a lark’s head knot. Gather the cords in pairs so that the 9th cord forms a pair with the ends of the magic ring.
Guide step %d
16   Place the ring around the edge of the jar and tighten it around the top edge.
Guide step %d
17   Close and tighten the ring with a knot. The ends form pairs with the 9th cord on the ring.
Guide step %d
18   Knot the pattern with four cords: 2 x 2 on each side. Tie a square knot around the two middle cords with the two outer cords. Make the knot 2.5 cm from the top edge, depending on the size of the jar.
Guide step %d
19   Make square knots all the way around for a total of five knots.
Guide step %d
20   Repeat a total of three times around the jar with five knots each time.
Guide step %d
21   Cut the ends 1 cm from the bottom of the jar so that they are even all the way around.
Guide step %d
22   Remove the knotted macramé from the jar and twist the cord with your fingers or a coarse comb.
Guide step %d
23   Place a damp tea towel over the ends and iron them flat.
Guide step %d
Crepe Flowers   Cut the petals out of crepe paper using the stencil. Remember to turn the stencil so that the lines follow the lines of the crepe paper. Cut 2 different sizes and 3 pieces for each flower.
Guide step %d
25   Stretch the strip for the centre of the flower stamen and roll the fringes.
Guide step %d
26   Roll the strip for the middle of the stamen and then roll it again.
Guide step %d
27   Apply a thin layer of glue to the bottom edge of the strip and glue it onto the stick. Start at one end and roll it on as you glue.
Guide step %d
28   Bend the top edge of the petals back and forth.
Guide step %d
29   Shape the bottom 1/3 of the leaf around your thumb and stretch the crepe paper.
Guide step %d
30   Glue on the three small petals in the opposite colour of the flower stamens.
Guide step %d
31   Pull them apart so that they overlap slightly.
Guide step %d
32   Place one of the three large petals on each overlap.
Guide step %d
Menu Card   Cut a hole in the middle of the top of the card.
Guide step %d
34   Place the desired design on the stamp block and dab colour onto it from the stamp pad. Stamp the upper left corner.
Guide step %d
35   Cut 45 cm pieces of satin ribbon and raffia ribbon. Thread them through the hole in the card and tie all four ends together in a knot.
Guide step %d
36   Cut the satin ribbon and raffia ribbon to 25 cm long and pull them through the hole in the wooden disc. If necessary, use a crochet hook to help you pull them through.
Guide step %d
37   Stamp designs on the wooden discs and write guest names with a marker.
Guide step %d
Template   Print the template here.
Attached file: Download
Also go exploring in

More Information

Set a creative table in soothing, natural colours. Make napkin rings and preserving jars in macramé and flowers out of crepe paper. You can also make place cards out of round wooden discs and handwritten menu cards, both decorated with attractive stamped designs.

More Information
SKUv16865
SeasonBasic

Description

Go back
I'm shopping as
Continue as guest
Your benefits of login

✔ Your personal wishlist

✔ See your order history

✔ Easy checkout
Your benefits of login

✔️ Your special prices

✔️ Special B2B products

✔️ B2B marketing universe
Your benefits of login

✔ Content especially for you

✔ Your special prices
Copyright © 2021-present Magento, Inc. All rights reserved.