Halloween jewellery made of wooden beads and clay

1 Knead and soften the clay by hand for around 4 minutes.

2 Press the clay into the silicone mould. Make sure the clay is pushed into all the details.

3 Use the flat end of the tool to scrape clay off the face. Also make sure that the stem at the top has no clay on it.

4 To make a ghost, roll two balls of 1 cm and 1.5 cm.

5 Roll out the largest ball into a circle that is 2 mm thick.

6 Place the small ball in the middle of the rolled out clay piece and carefully fold down the edges around the ball to form a small ghost.

7 Use the eye pin to make a hole through the middle of the ball. Twist the pin a few times to make the hole larger.

8 Bake the clay in a preheated oven at 120 degrees for 18 minutes. The pumpkins should remain in the silicone mould. After baking, allow to cool and then harden for 2-3 hours.

9 Draw on eyes and also a mouth if desired on the ghosts using the black marker.

10 Press the pumpkins out of the silicone mould.

11 Thread wooden beads and charms alternately onto the elastic cord for the necklace and bracelet.

12 Tie a knot on the elastic cord once the necklace/bracelet is the desired length.

13 Cut off the excess elastic cord and hide the knot in a bead if desired.