Several Bracelets in One – assembled in Fold-Over End Caps

#v13496

This bracelet is composed of six individual bracelets made using different techniques; plaiting, braiding and weaving on a LoopDeDoo spinning tool and a bead loom. All the bracelets are assembled into one bracelet using a fold-over end cap at each end.

#v13496
Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

How to do it
Guide step %d
1.   A twisted bracelet: Wrap the macramé cords around the LoopDeDoo device and keep the looping cord tight with one hand (holding the hand close to the bracelet). Turn the handle with the other hand.
Guide step %d
2.   A braided bracelet with rhinestones: Attach a doubled-over piece of macramé cord onto the hooks. Place the rhinestone jewellery chain on top and secure it with a piece of yellow macramé cord. NB: Braid a couple of knots after each rhinestone. See idea number 12499 for further instructions.
Guide step %d
3.   A plaited bracelet: attach three doubled-over pieces of macramé cord onto the LoopDeDoo device and plait to a desired length. NB: make sure that the cords lie flat whilst plaiting.
Guide step %d
A Bracelet woven on a Bead Loom   Thread the beam loom following the enclosed instructions. Use a beading needle and rocaille seed beads when weaving. You may draw the pattern on a piece of graph paper beforehand. See idea number 12858 for further instructions.
Guide step %d
A Bracelet with Clay Beads   Thread Indian beads onto a piece of elastic beading cord using a beading needle.
Guide step %d
Assemble all the bracelets into one bracelet   Trim all the ends and secure with glue.
Guide step %d
1.   Gather all the different individual bracelets and keep them in place securely with a piece of masking tape.
Guide step %d
2.   Apply glue on both inner sides of a fold-over end cap. Place each end of the assembled bracelets inside the fold-over end cap (with one end cap at either end of the bracelet).
Guide step %d
3.   Use flat nose pliers and carefully squeeze the fold-over end caps together. Let them dry for three to four hours.
Guide step %d
4.   Attach an oval ring at one end of the fold-over end cap. Attach an oval ring with a lobster claw clasp at the other end of the bracelet.
Also go exploring in
Copyright © 2021-present Magento, Inc. All rights reserved.