5576bbd629a09.jpg)
Creative idea
Plaited Bracelets from Macramé Cord and with Click Fasteners
#v14079
These bracelets with click fasteners are both made from macramé cord, plaited into a thick plait.
#v14079
How to do it
1. 
Cut three pieces of macramé cord each measuring 65cm. Thread all three through the hole on one part of the two-part click fastener. Attach this onto a clip board. NB: make sure to arrange the cords at equal lengths.
Cut three pieces of macramé cord each measuring 65cm. Thread all three through the hole on one part of the two-part click fastener. Attach this onto a clip board. NB: make sure to arrange the cords at equal lengths.2. 
Plait the three doubled-over cords into a plait.
Plait the three doubled-over cords into a plait.3. 
When the desired length is reached, thread one cord from each of the doubled-over cords through the hole of the other part of the two-part click fastener.
When the desired length is reached, thread one cord from each of the doubled-over cords through the hole of the other part of the two-part click fastener.4. 
Trim the ends, melt them with a lighter and immediately push them into the bracelet to secure them. You may use textile glue for securing the ends. Use a clamp to keep the ends secure during the drying time.
Trim the ends, melt them with a lighter and immediately push them into the bracelet to secure them. You may use textile glue for securing the ends. Use a clamp to keep the ends secure during the drying time.Also go exploring in
