Keyring Fobs made from Shrink Plastic Sheets and neon Markers

SKU#:
v13020

Keyring Fobs made from Shrink Plastic Sheets and neon Markers

SKU#:
v13020

A keyring fob made from black shrink plastic sheets, decorated with Neon Deco Fabric Markers. Cut out and make a hole. Then shrink it in the oven. A piece of black elastic cord with neon-coloured beads and a split ring is attached.

Your Customization
Creative idea
Keyring Fobs made from Shrink Plastic Sheets and neon Markers
Keyring Fobs made from Shrink Plastic Sheets and neon Markers

In stock

€3.84

Summary
    Creative idea
    How to do it
    Guide step %d
    1.
    Draw a figure on a piece of A6 black shrink plastic foil and cut it out.
    Guide step %d
    2.
    Use revolving punch pliers to make holes in the figure. Use the largest possible hole size on the revolving punch pliers and make three or four holes very close to each other, so the hole is sufficiently large after the shrinking!
    Guide step %d
    3.
    Place the plastic figure on a piece of baking paper on a baking tray and place it in a pre-heated oven at 160°C for approx. 40 seconds. Open the oven door ajar, and leave the figure in the oven until it unfolds again.
    Guide step %d
    4.
    Thread the beads onto the doubled-over piece of elastic cord by using a piece of doubled-over floral wire as a needle. Tie on the figure using a double knot and attach the split ring onto the other end of the elastic cord.
    Copyright © 2013-present Magento, Inc. All rights reserved.