Braided Bracelets with coloured Howlite

#v12500

Bracelets braided from semi-gloss polyester cords with colourful howlite beads.

#v12500
Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

How to do it
Guide step %d
1.   Cut a 150cm piece of 2mm macramé cord measuring 150cm and it double over. Braid around a 1mm cord measuring approx. 40cm. Braid beads onto the cord as you go along. See the technique below.
Guide step %d
2.   Fasten the bracelet by braiding a cord around the two parallel pieces of 1mm cord. See the technique below.
Guide step %d
3.   Tie a triple knot and melt it lightly.
Guide step %d
A.   Braiding Technique: A clip board  is used for starting and supporting the braiding. Attach the cords under the clip. Thread beads onto the middle cord.
Guide step %d
B.   Follow steps B to I. Start again and switch from right to left until the desired length is reached.
Guide step %d
C.   -
Guide step %d
D.   -
Guide step %d
E.   -
Guide step %d
F.   -
Guide step %d
G.   -
Guide step %d
H.   -
Guide step %d
I.   -
Guide step %d
J.   Push up the beads when they are needed.
Guide step %d
K.   Place the middle cords parallel and braid an additional piece of cord over the two middle cords.
Guide step %d
L.   Cut off the ends leaving approx. 1cm.
Guide step %d
M.   Melt the ends one by one with a lighter and immediately push them into the braided section with a pair of scissors (for example) so they melt together.
Also go exploring in
Copyright © 2021-present Magento, Inc. All rights reserved.