Papier-mâché Boxes decorated like Drums with Faux Leather Paper, Plastic Rings and natural Twine

#v15469

These papier-mâché drum boxes are decorated with faux leather paper and natural twine attached with plastic rings.

Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
1   Copy the outline of the bottom and top of the papier-mâché drum box onto faux leather paper. Cut out the circles. Measure the circumference and width of the edge of the bottom and top. Add another 1.5 mm onto the width. Draw two strips with these measurements onto the faux leather paper and cut out.
Guide step %d
2   Glue on the faux leather paper parts using VTR Glue. Apply glue to the faux leather paper as well as the drum box because the faux leather paper is very absorbent. You may keep the faux leather paper in place with an elastic band whilst the glue dries.
Guide step %d
3   Measure the circumference of the drum. Put on the lid and measure from one edge to the other (top to bottom). Add another 1 cm to the measurement. Cut a piece of black faux leather paper according to the measurements. Apply VTR glue and attach the faux leather paper onto the drum. Slide the paper down under the bottom edge so that no white edge is showing.
Guide step %d
4   Trim the excess faux leather paper at the top.
Guide step %d
5   Cut a piece of white paper matching the circumference of the drum (the circumference of the large drum box is 40 cm). The length is measured from edge to edge (top to bottom) between lid and bottom. Draw a pattern as shown in the photo, so that there are 8 equal squares in total. Mark the points at the top of the box so you can make holes.
Guide step %d
6   Make holes at the markings using revolving hole punch pliers.
Guide step %d
7   Cut 1 m of natural twine and apply a bit of VTR Glue at one end. Feed the twine through a hole from the inside and tie a knot on the inside of the drum box. Thread a ring onto the twine. Attach the twine at the bottom of the drum box (see the next step). Thread another ring onto the twine and feed the twine through every other hole as illustrated in the photo.
Guide step %d
8   Attach the twine at the bottom by pushing it down behind the edge with a small blob of glue. You may use the points of a pair of scissors. Tie the two twine ends together once you have gone all the way around the drum box. Cut another 1 m piece of natural twine and attach this in the same manner as described above through the empty holes.
Also go exploring in
Go back
I'm shopping as
Continue as guest
Your benefits of login

✔ Your personal wishlist

✔ See your order history

✔ Easy checkout
Your benefits of login

✔️ Your special prices

✔️ Special B2B products

✔️ B2B marketing universe
Your benefits of login

✔ Content especially for you

✔ Your special prices
Copyright © 2021-present Magento, Inc. All rights reserved.