A Unicorn Keyring Fob from Shrink Plastic

SKU
v14857

A Unicorn Keyring Fob from Shrink Plastic

SKU
v14857

These pre-printed designs on shrink plastic are coloured in with colouring pencils. The figures are cut out, a hole is made at the top, they are shrunk in a household oven at 170°C and attached to a keyring to make a key fob.

Select products for the idea

* Required Fields

Samlet pris for valgte produkter
Your Customization
Creative idea
A Unicorn Keyring Fob from Shrink Plastic
A Unicorn Keyring Fob from Shrink Plastic

In stock

€3.10

Summary
    Creative idea
    How to do it
    Guide step %d
    1
    Colour in the pre-printed design on the shrink plastic sheet using colouring pencils.
    Guide step %d
    2
    Cut out the figure with a pair of scissors and make a hole at the top using punch pliers. It can then be attached as a key fob on a keyring. Remember that the hole shrinks as well.
    Guide step %d
    3
    Place the figure on a baking sheet covered with baking paper. Put in a household oven at 170°C. After a few minutes the figure will start to shrink and curl up and then it straightens out again and can be taken out of the oven.
    Guide step %d
    4
    Attach the figure to the keyring using a round jump ring. Now squeeze the round jump ring with flat nose pliers to close it.
    Guide step %d
    Another example
    -
    Copyright © 2013-present Magento, Inc. All rights reserved.