A Macramé Bracelet with Metal Link

#v13476

This bracelet with a metal link is braided using the macramé technique. The fastening is an oval jump ring attached to each of the end caps. A swivel clasp is attached to one of the oval jump rings.

#v13476
Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

How to do it
Guide step %d
1.   Attach a metal link onto the clip board. Thread a 25cm piece of cotton cord through the hole of the metal link. Braid around the cotton cord using another 80cm piece of cotton cord.
Guide step %d
2.   Braid a 5cm section measured from the hole of the metal link. Remove the metal link from the clip board. Now turn it and repeat the procedure at the opposite end of the metal link by threading a 25cm piece of cotton cord through the other hole of the metal link.
Guide step %d
3.   Trim both braided ends and attach each end in an end cap using glue.
Guide step %d
4.   Attach an oval ring with an attached swivel clasp in one of the end caps. Attach an oval ring in the other end cap.
Guide step %d
Another variant   Same procedure – a different color.
Guide step %d
Another variant   NB: If you want a smaller metal link in the bracelet then each of the braided sections must be longer, for instance, 7.5cm as shown here.
Guide step %d
Another variant   A double length bracelet with a metal charm: Cut a 280cm piece of cotton cord. Use this for braiding around a 75cm piece of cotton cord which is attached to a clip board. Braid 7.5cm, then thread the metal charm onto the cord and braid the last 25cm. NB: the metal charm is not meant to be threaded onto the middle of the cord.
Guide step %d
Another variant   A metal charm with a transversal vertical hole on a double length bracelet.
Guide step %d
Another example   -
Also go exploring in
Copyright © 2021-present Magento, Inc. All rights reserved.