A Leather Cord Necklace with a Heart
#v12112
This necklace is braided using leather cords and closed with large end caps. A big heart is attached in front.
#v12112
How to do it

1. Cut five pieces of leather cord, each measuring approx. 50cm (they must all be exactly the same length). Double over and assemble the cord ends with a small amount of Super Attak Instant Glue prior to gluing them into an end cap. (Squeeze well).
.jpg)
2. Put a small leather cord through the loop of the end cap and fasten it onto a clipboard. Put three loops onto three fingers on your left hand and two loops onto two fingers on your right hand. Keep your right index finger free.

5. Now use your left index finger to move the loop on the far right side over and down into the middle.

6. Tighten the loops on each side after each changed position of the loops. Continue to switch sides until the desired length of this section of the necklace is reached. This necklace has a 17cm plaited section between the two end caps. Do not let go.

8. Trim the ends and assemble with some glue. Squeeze well together and glue into the end cap. (Put the glue into the end cap and not onto the leather cords). Braid an identical section for the opposite side of the necklace.

9. Use a piece of cord to tie a knot onto the loop of the end cap. Pull both ends of the cord through the heart.
Also go exploring in