A Fimo Modelling Clay Pendant in an Aluminium Wire Frame

#v14025

Both pendants are made from Fimo modelling clay which is hardened in the oven. A flat piece of aluminium wire is glued all the way along the edge. A bead cap is inserted for hanging. An oval jump ring is attached to the loop of the bead cap.

#v14025
Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

How to do it
Guide step %d
1.   Roll the clay flat and to the same thickness as the width of the aluminium wire. Use a rolling pin.
Guide step %d
2.   Print and cut out the template which is available as a separate PDF file for this idea. Cut out the clay shape as precisely as possible.
Guide step %d
3.   Cut a minimum 10 cm piece of flat aluminium wire. Make a hole in the middle of the aluminium wire for hanging the pendant. Use a hammer and a thin nail for this. Using the same tools, make an indentation of approx. 2-3 mm at the top of the shape.
Guide step %d
4.   Harden the shape in the oven for 30 min at 110°C.
Guide step %d
5.   Apply glue along the top edge of the shape. Push the bead cap through the hole in the flat aluminium wire and further down into the small hole in the shape. Push together and leave to dry.
Guide step %d
6.   Bend and shape the aluminium wire around the Fimo modelling clay shape and cut off the excess wire.
Guide step %d
7.   Carefully lift away the aluminium wire from the shape. Apply glue to the sides of the shape and attach the aluminium wire.
Guide step %d
8.   Insert an oval jump ring to the loop on the bead cap. Then attach the finished pendant to a piece of jewellery chain, assembled with an oval jump ring.
Guide step %d
Template   -
Attached file: Download
Also go exploring in
Copyright © 2021-present Magento, Inc. All rights reserved.