Creative idea
A Dream Catcher made from a Metal Ring wound with Cotton Yarn and decorated
#v14719
This dream catcher is a metal ring, wound all the way around with cotton yarn. The yarn is also used for 'weaving' inside the ring and for hanging with a bead. Cotton yarn is also used for three pendants at the bottom, each of which are decorated with a bead and a feather respectively.
#v14719
How to do it
1 
Wind the yarn tightly all the way around the metal ring. Tie the two ends together with a knot when they meet.
Wind the yarn tightly all the way around the metal ring. Tie the two ends together with a knot when they meet.2 
Divide the ring, for example, into eight equal sections and make a small ball of cotton yarn. Tie the yarn at each point and weave from one point to the next.
Divide the ring, for example, into eight equal sections and make a small ball of cotton yarn. Tie the yarn at each point and weave from one point to the next.3 
Another example
Another example4 
Continue round the ring and work towards the middle, one section to the next in the middle of each string of yarn – under and over respectively. Remember to tighten as you go along.
Continue round the ring and work towards the middle, one section to the next in the middle of each string of yarn – under and over respectively. Remember to tighten as you go along.5 
Another example
Another example6 
Pull the yarn up in the middle, tie a knot and trim. A TIP: You may put a blob of glue onto the knot to make sure that the yarn end is kept in place.
Pull the yarn up in the middle, tie a knot and trim. A TIP: You may put a blob of glue onto the knot to make sure that the yarn end is kept in place.7 
Pendants on the dream catcher: Cut three pieces of yarn and tie them at three points between two sections. Thread a bead onto each piece of yarn and finish with 2-3 knots. Trim the excess ends.
Pendants on the dream catcher: Cut three pieces of yarn and tie them at three points between two sections. Thread a bead onto each piece of yarn and finish with 2-3 knots. Trim the excess ends.8 
Decorate the pendants. Push a blob of glue inside each bead and attach a feather inside the bead. Leave to dry. Hanging: Cut a piece of cord, tie it onto the top of the ring and thead on a bead.
Decorate the pendants. Push a blob of glue inside each bead and attach a feather inside the bead. Leave to dry. Hanging: Cut a piece of cord, tie it onto the top of the ring and thead on a bead.Also go exploring in
