A Card with Stamp Printing

1   First push out the roller.

2   Open the roller by pulling out the two orange pins.

3   Remove the stamp design from the sheet and attach it to the roller.

4   Wrap the stamp around the roller and fasten it in the other end.

5   Assemble the roller by pushing the two pins back in place.

6   Push the roller back in the holder. There must be an audible click indicating that it is now in place.

7   Turn the holder so that the Fiskars logo is turned towards you. Push the ink pad in place at the top of the holder.

8   Remove the lid of the ink pad.

9   Turn the ink pad down towards the stamping roller.

10   You make the stamp printing by pushing the roller forwards in a smooth motion. You can stamp on many types of paper. We have used watercolour paper in this example.

11   Colour the patterns with watercolour pencils. If you want a blurred look, colour lightly. You may mix the colours. Put a little water on a small brush, and drag it around in the colours. Be careful not to get too close to the ink itself, as it could dissolve.

12   Cut a piece of Music Notes Vellum Paper slightly smaller than the card. Cut the stamp print to fit lengthwise and attach both to the card. We have used E-Z runner for vellum which is not visible from the front. Attach two pieces of ribbon on either side of the stamp print. You may decorate with a small punched out flower attached with 3D foam pads.