A Bracelet made from a Rhinestone Jewellery Chain and Cotton Cord

#v13477

This bracelet is made from a rhinestone jewellery chain with cotton cord braided around it in a crossbraided fashion. An end cap is attached at each end to which an oval jump ring is attached. Attach a swivel clasp to one of the oval jump rings.

#v13477
Select products for the idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Total price
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

How to do it
Guide step %d
1.   Cut a piece of rhinestone jewellery chain measuring approx. 17cm and a 70cm piece of cotton cord. Tie the latter at the top between the two first rhinestones on the jewellery chain, making sure that there are two equal length ends on either side of the jewellery chain in the middle. Glue into an end cap and let it dry.
Guide step %d
2.   Attach the end cap with the jewellery chain and the doubled over cord middle onto a clip board. Use masking tape and attach a rubber underneath the end of the jewellery chain as shown. This is in order to attach the jewellery chain with pins as it has to be suspended slightly above the clip board during the braiding process.
Guide step %d
3.   Then cross braid the two lengths of cotton cord over and under the jewellery chain till the end of the cords is reached. Finish by tying between the two last rhinestones.
Guide step %d
4.   Cut off the excess cord and attach the cord ends and the other end of the jewellery chain with glue in an end cap. (The photo shows the back of the cross braiding).
Guide step %d
5.   Attach an oval ring in each of the end caps. Attach a swivel clasp in one of the oval rings.
Also go exploring in
Copyright © 2021-present Magento, Inc. All rights reserved.