A Party Invitation and Card with Punched-Out Decorations

1. Cut a piece of white card slightly smaller than that of the blank card (i.e. 7mm on three sides and 3.5mm at the top). Attach this to the blank card with double-sided adhesive tape.

2. Use the Border Punch tool to punch a border from white card. After the first punch, move the tool to the right, so the pattern reaches the desired length. Punch again.

3. Cut the border away from the white card.

4. Attach it to the blank greeting card using small pieces of double-sided adhesive tape where possible not to obstruct the laced pattern.

5. Attach the pearlescent paper, the gold paper and the printed text in layers using double-sided adhesive tape.

6. Tie a piece of gold thread around the front of the greeting card. Thread a mother-of-pearl heart onto one end of the thread and attach a feather to the other end.

7. Decorate with dots made with a Pearl Pen.

8. Menu card: Cut a piece of card measuring approx. 21 x 10.5cm. Score across the middle and fold to make it a double-sided square card. Place the Border Punch on the front of the card, let the arrow on the actual tool point to the middle of the front of the card (measure and mark). Pull the tool 7mm back and punch the design into the card.

9. Cut out the various pieces of card and paper and attach these onto the menu card as decoration following the same procedure as described previously.

10. Fold up the outer part of the punched-out heart, so it appears in 3D.